REPTI PLANET Mister 1 pc
Ultrasonic fog generator.
Using an ultrasonic ceramic membrane, it produces cold water mist at normal temperature, which can increase humidity in a terrarium (or room) and generates negative ions to freshen the air.
- Imitates the morning mist in desert terrariums and simulates tropical mist in tropical terrariums
- Depending on the size of the terrarium, it increases air humidity up to 100%
- Automatic protection at low water level: In case of insufficient water (<3 cm), the Fogger switches off automatically
- Suitable not only for terrariums, but also for other water containers
- Amazing visual effect
- Replacement REPTI PLANET membranes can be purchased separately
Warning: Always make sure there is a sufficiently high water level in the tank.
Ultrasonic fog generator – Instructions
Manual
Using an ultrasonic ceramic membrane, this product produces cold water mist at normal temperature, which can increase humidity in the terrarium (room) and creates negative ions to refresh the air. The product can also be used as a decoration – e.g. a miniature fountain with an interesting misting effect.
Operating specifications:
1. Place the Fogger in a water container and keep it level (the optimal water level height is 20 mm to 40 mm above the ceramic disc).
2. Connect the Fogger's power cable to the transformer. Plug the transformer cable into the electrical socket. The Fogger will start producing water mist. At the same time, the LED will light up.
Notes:
1. Do not handle the Fogger after connecting it to the power supply, as this could damage the device.
2. Do not leave the Fogger switched on for more than 10 hours a day.
3. Do not touch the ceramic disc while the Fogger is operating.
4. Use in clean water; dirty water reduces the Fogger's operating time.
5. Disconnect the power supply before relocating or servicing.
6. The ceramic membrane is a consumable and its service life is approximately 3000 hours. If you notice a reduction in the amount of mist produced, clean the ceramic membrane with a cotton swab (do not use any detergents). If there is still less mist after cleaning, replace the used membrane with a new one.
7. When replacing with a new ceramic membrane, install it according to the instructions in the manual. Make sure the inside of the device is completely dry and remember to install the ceramic membrane with the correct side (the side without the black loop) facing up.
Fogger parameters
Input voltage: A / C 24 V
Input electrical current: 400 mA
Power: 12 W
Operating temperature: + 5 ° C - + 45 ° C
Water output: > 250 ml / h
Ideal water depth: 2.5 - 3.5 cm above the ceramic
- Depending on the size of the terrarium, it increases air humidity up to 100%
- Automatic protection at low water level: In case of insufficient water (<3 cm), the Fogger switches off automatically
- Suitable not only for terrariums, but also for other water containers
- Amazing visual effect
- Replacement REPTI PLANET membranes can be purchased separately
Warning: Always make sure there is a sufficiently high water level in the tank.
Ultrasonic fog generator – Instructions
Manual
Using an ultrasonic ceramic membrane, this product produces cold water mist at normal temperature, which can increase humidity in the terrarium (room) and creates negative ions to refresh the air. The product can also be used as a decoration – e.g. a miniature fountain with an interesting misting effect.
Operating specifications:
1. Place the Fogger in a water container and keep it level (the optimal water level height is 20 mm to 40 mm above the ceramic disc).
2. Connect the Fogger's power cable to the transformer. Plug the transformer cable into the electrical socket. The Fogger will start producing water mist. At the same time, the LED will light up.
Notes:
1. Do not handle the Fogger after connecting it to the power supply, as this could damage the device.
2. Do not leave the Fogger switched on for more than 10 hours a day.
3. Do not touch the ceramic disc while the Fogger is operating.
4. Use in clean water; dirty water reduces the Fogger's operating time.
5. Disconnect the power supply before relocating or servicing.
6. The ceramic membrane is a consumable and its service life is approximately 3000 hours. If you notice a reduction in the amount of mist produced, clean the ceramic membrane with a cotton swab (do not use any detergents). If there is still less mist after cleaning, replace the used membrane with a new one.
7. When replacing with a new ceramic membrane, install it according to the instructions in the manual. Make sure the inside of the device is completely dry and remember to install the ceramic membrane with the correct side (the side without the black loop) facing up.
Fogger parameters
Input voltage: A / C 24 V
Input electrical current: 400 mA
Power: 12 W
Operating temperature: + 5 ° C - + 45 ° C
Water output: > 250 ml / h
Ideal water depth: 2.5 - 3.5 cm above the ceramic
| Category: | Misters and Foggers |
|---|---|
| Weight: | 0.7 kg |
| EAN: | 8595091794362 |
| Brand: | Repti Planet |
Product rating
Be the first who will post an article to this item!
| Manufacturing company : | Plaček Pet Products s.r.o. |
|---|---|
| Address : | Revoluční 1381/III, 290 01 Poděbrady, CZ |
| E-mail : | info@placek.cz |
